Alsa Refinish KC-ABP-16 Instruction Manual download pdf

BASE PEARLS KILLER CAN

How to Apply (Application Steps)

1 If your piece already has primer applied, proceed to step number 11. If your piece

already has primer AND a WHITE base coat applied, then lightly scuff the surface for

adhesion, and proceed to step number 12. If your piece already has a factory finish on

it, that is not white, you can lightly scuff that, and proceed to step 11. If your piece

already has a factory finish on it that is white, you can simply scuff that and proceed to

step number 12.

2 Always apply paints in a well-ventilated area, and wear a NIOSH approved respirator

to avoid breathing any fumes.

3 Make sure you have good conditions for spraying. The best temperature for spraying

this paint, is 75-80 degrees F, and VERY low humidity.

4 Prepare and prime your part first. Epoxy primers are best for bare metal, and primer

surfacers are best for plastics, fiberglass, or wood. Some plastics may require an

adhesion promoter but most plastics, like ABS plastic, are fine without adhesion

promoters. Our tech support department can assist with what primer is best, if you are

uncertain.

5 Before applying your primer, remove all dirt, grease, oil, salt, and chemical

contaminants, by washing the surface with a commercial detergent, or other suitable

cleaning method.

6 Rinse with fresh water and allow to completely dry.

7 Remove any existing loose paint, or rust, etc, with a wire brush or sand paper.

8 Lightly sand glossy surfaces to create a surface profile for adhesion.

9 Apply your primer to the surface according to the manufacturers specifications for your

particular primer.

10 Let your primer cure according to the manufacturers specifications for your particular

primer, and then lightly scuff that to create a surface profile for adhesion.

11 Apply a white base coat (such as Alsa’s Pure White, part number “KC-ASB-14) as your

under coat for your base pearls (unless using Alsa’s “Black Gold” peal paint, in which

case use a BLACK base coat, such as Alsa’s Jet Black, part number “KC-ASB-13”).

12 Now apply your “Alsa Base Pearl” base coat, using steady even passes, from about 8-

10 inches away from the substrate, until you achieve an even coverage.

13 If a second coat is required, let the first coat flash for about 10-15 minutes, and then

apply your second coat over that, again, making sure to use steady even passes.

1 2

BASE PEARLS KILLER CAN 1

Summary of Contents

Page 1 - BASE PEARLS KILLER CAN

BASE PEARLS KILLER CANHow to Apply (Application Steps)1 If your piece already has primer applied, proceed to step number 11. If your piece already h

Page 2

14 Let your base coat flash for approximately 10-15 minutes, and then apply any high quality clear coat (such as Alsa’s Mirraclear, part number KC-MCL

Comments to this Manuals

No comments

Alsa Refinish KC-ABP-16 Instruction Manual

Browse online or download Instruction Manual for Unknown Alsa Refinish KC-ABP-16. Alsa Refinish KC-ABP-16 Instructions / Assembly User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Alsa Refinish KC-ABP-16