Alsa Refinish KC-KC101 Instruction Manual download pdf

KILLER CHROME KILLER CAN

How to Apply (Application Steps)

Surface Preparation:

1 Always apply paints in a well-ventilated area, and wear a NIOSH approved respirator

to avoid breathing any fumes.

2 Make sure you have good conditions for spraying. The best temperature for spraying

this paint, is 75-80 degrees F, and VERY low humidity.

3 Prepare and prime your part first. Epoxy primers are best for bare metal, and primer

surfacers are best for plastics, fiberglass, or wood. Some plastics may require an

adhesion promoter but most plastics, like ABS plastic, are fine without adhesion

promoters. Our tech support department can assist with what primer is best, if you are

uncertain.

4 Before applying your primer, remove all dirt, grease, oil, salt, and chemical

contaminants, by washing the surface with a commercial detergent, or other suitable

cleaning method.

5 Rinse with fresh water and allow to completely dry.

6 Remove any existing loose paint, or rust, etc, with a wire brush or sand paper.

7 Lightly sand glossy surfaces to create a surface profile for adhesion.

8 Apply your primer to the surface according to the manufacturers specifications for your

particular primer.

9 Let your primer cure according to the manufacturers specifications for your particular

primer, and then lightly scuff that to create a surface profile for adhesion.

Killer Chrome Application:

Killer Chrome is a VERY technique driven application. It is sold as a kit, as it is very sensitive

to clears. You should only use OUR clear coat with this material. Any good black urethane

base coat should be fine.

This application can take a fair amount of practice to become proficient with. Patience is the

KEY.

Test panels are strongly urged, in order to develop the correct “FEEL” for spraying the

chrome material. A very light dusting technique will be needed, and is critical to the

application. Over applying the Killer Chrome will result in a dull finish, similar to silver paint.

1 2 3 4

KILLER CHROME KILLER CAN 1

Summary of Contents

Page 1 - KILLER CHROME KILLER CAN

KILLER CHROME KILLER CANHow to Apply (Application Steps)Surface Preparation:1 Always apply paints in a well-ventilated area, and wear a NIOSH approv

Page 2

Application:If applying over an ALREADY PAINTED SURFACE, lightly scuff the existing paint to create a surface for adhesion.1 We are starting with the

Page 3

You are now ready to begin chroming your piece.4 Apply the Killer Chrome (KC-KC101) to your clear coated black base coat, in a VERY LIGHT DUSTING FASH

Page 4

Do not apply too much pressure when wiping the killer chrome down, or you may move the pigment that is STUCK to the clear coat, and that will spoil th

Comments to this Manuals

No comments

Alsa Refinish KC-KC101 Instruction Manual

Browse online or download Instruction Manual for Unknown Alsa Refinish KC-KC101. Alsa Refinish KC-KC101 Instructions / Assembly User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Alsa Refinish KC-KC101